Re: HP Envy 6455e flashing E6 General printer failure

Hi @NVee,

Welcome to HP Support Community.

Thank you for posting your query, I will be glad to help you.

The "E6 General Printer Failure" on the HP Envy 6455e, accompanied by all the lights flashing and the power button being unresponsive, typically indicates a hardware or firmware issue. Here's how to troubleshoot the problem.

Perform a Power Reset

1. Turn off the printer by unplugging it from the power source.
2. Wait 60 seconds to ensure the printer completely resets.
3. Plug the printer back into a direct wall outlet (avoid surge protectors or power strips).
4. Turn on the printer and check if the issue persists.

Check for Paper Jams or Obstructions

1. Open the printer cover and check for any paper jams or foreign objects inside.
2. Remove any visible obstructions carefully to avoid damaging the printer.
3. Ensure the paper is loaded correctly in the input tray.

Reset the Printer

1. With the printer powered on, unplug the power cord from the back of the printer.
2. Disconnect the power cord from the wall outlet.
3. Wait two minutes.
4. Reconnect the power cord to the printer and the wall outlet.
5. Turn the printer back on.

Update Firmware

If the printer powers on successfully:

1. Ensure the printer is connected to a network.
2. Use the HP Smart app or the printer's web interface to check for and install firmware updates.

Perform a Factory Reset

If the issue persists:

1. Turn off the printer.
2. Press and hold the Power button and Cancel button (or a combination listed in your printer's manual for a factory reset).
3. Continue holding the buttons until the printer restarts.

I hope this helps.

Take care and have a good day.

Please click “Accepted Solution” if you feel my post solved your issue, it will help others find the solution. Click the “Kudos/Thumbs Up" on the bottom right to say “Thanks” for helping!

Alden4

HP Support