Hi @MarkDP1,
Welcome to HP Support Community.
Thank you for posting your query, I will be glad to help you. 🙂
As I understand the blue screen with the error message: 00829C98
Don't worry as I'll be glad to help, however, to provide an accurate resolution
In some cases, removing the ink cartridges and resetting the printer can clear the error message.
1. Turn on the printer.
2. Wait until the printer is idle and silent before you continue.
3. Disconnect the USB cable from the rear of the printer. If your printer has a network or wireless connection, leave it connected.
4. Remove the ink cartridges from the printer.
5. With the printer turned on, disconnect the power cord from the rear of the printer and from the wall outlet or power strip.
6. Wait at least 60 seconds.
7. Plug the power cord back into the wall outlet.
8. Reconnect the power cord to the rear of the printer.
9. Turn on the printer, if it does not automatically turn on.
The printer might go through a warm-up period. The printer lights might flash, and the carriage might move.
10. Wait until the warm-up period finishes and your printer is idle and silent before you proceed.
11. Reinsert the ink cartridges, and then close the ink cartridge access door.
12. If you receive a prompt to print a calibration page, do so.
13. If you disconnected the USB cable, reconnect it to the rear of the printer.
14. Try to print.
Also, please try updating the firmware, you may refer this document - Update the firmware on an HP printer | HP® Support
I hope this helps.
Take care and have a good day.
Please click “Accepted Solution” if you feel my post solved your issue, it will help others find the solution. Click the “Kudos/Thumbs Up" on the bottom right to say “Thanks” for helping!
Max3Aj
HP Support